The following principles must be followed when adjusting the rotary kiln supporting roller:

When adjusting the supporting rollers, the center line of the kiln body must be in a straight line. The proper position for adjusting the supporting rollers is that the centerlines of the supporting rollers are in the same direction, and the angle of inclination is basically the same; be careful before adjusting the supporting rollers, and the number of times of adjusting the rollers should be minimized.

If the adjustment work of the supporting roller must be carried out, the following points must be paid attention to when readjusting:

1.When adjusting the kiln supporting rollers, you cannot only adjust one of them, but must be adjusted in pairs, and the supporting rollers must not be adjusted to the shape of "八".

2. The logarithm of the adjusted roller can be reduced as much as possible, and the adjustment angle can also be as small as possible.

3. When adjusting the supporting roller of the rotary kiln, the top wire is only allowed to rotate at 90℃-180℃ each time.

4. When adjusting the supporting roller, the center line of the supporting roller group and the cylinder must not be adjusted in different directions.

5. If it is because the kiln is not rotated in time when the kiln is stopped, the cylinder body is temporarily bent. Generally speaking, no adjustment work is performed. When the rotary kiln is re-rotated for 1-2 shifts, the cylinder body will generally be automatically straightened.