Newsroom
Troubleshooting plan for rotary kiln tyre
2022-08-05 | Editor:
In the event of a failure of the kiln tyre, the first emergency stop should be made, the oil pressure of the middle thrust roller should be disconnected, and the axial rise and fall should be controlled by the tail thrust roller.
Following the instructions below can also reasonably reduce the failure between the kiln tyre and the thrust roller, which is a good way to reduce the equipment failure rate.
1. Inject grease into the bearing surface of the third gear supporting roller to force the kiln body to descend axially until the horseshoe between the guide rods on both sides of the rear gear roller is fully compressed.
2. Unload the oil pressure in the oil cylinder of the rear thrust roller.
3. It takes 1.5min to rotate the rotary kiln at a slow speed.
4. Push the kiln body to its axial upward position through the hydraulic device of the rear thrust roller, so that the middle kiln tyre and the middle thrust roller are out of contact, and the gap between the two can be maintained at a distance of 20mm.
5. Tighten the horseshoe pads between the guide rods on both sides of the rear thrust roller.
CHAENG recommends users reasonably control the axial rise and fall of the rotary kiln when using the rotary kiln so that it can drive the pinion gear and the girth gear on the cylinder to achieve uniform wear and prolong its service life.
Order online
Fill out your message and submit it . Options with * must be filled in.
PRODUCTS
CONTACT
- Tel: +8615290747879
- Whatsapp: +8615290747879
- E-mail: casting@chaeng.co
- Skype : GreatWall1958
